#128: How to install optional filters in an Icom IC706MkIIG and measure them with an FFT

This video shows how to install the available optional IF filters in an Icom IC-706MkIIG ham radio transceiver. This is the same rig that was feature in the previous two “Repair Log” videos. The links to those videos an be found below.
Part 1: https://www.youtube.com/watch?v=tWRpJhlE5kU />Part 2: https://www.youtube.com/watch?v=F3u7uj6bmwE />The noise source used is a little kit from Elecraft which can be found here:
http://www.elecraft.com/mini_module_kits/mini_modules.htm
..about 2/3 the way down the page. Creates wideband noise from 100kHz to 500MHz.

Leave a Reply

Your email address will not be published. Required fields are marked *

Available for Amazon Prime