#315: How to use the NanoVNA to measure a low-pass filter

This video shows, step-by-step, how to use the NanoVNA to measure a simple lowpass filter. The filter used in the video was originally featured in the Michigan Mighty Mite video (#228):
https://www.youtube.com/watch?v=2AdW9Zpl2Es />The video walks through trace selection and configuration, sweep setup, calibration and measurement. Please note that when running the calibration, the OPEN, SHORT and LOAD are connected to CH0 (not CH1). Please see my previous videos on VNA calibration, VNA basics, and other topics including Smith Charts to learn more. Notes from this video can be found here:
http://www.qsl.net/w2aew/youtube/nanoVNA_filter.pdf
The filter design software I used was from here:
http://www.tonnesoftware.com/elsie.html

Leave a Reply

Your email address will not be published. Required fields are marked *

Available for Amazon Prime